Classic Flip-it!

Instructions for installing and using the Classic Flip-it!

These instructions apply to all sizes of Flip-it!s. Be sure to read about how to adjust the reflector panel.

Instructions for any Flip-it! or Diffuser product may be printed out here.

Attaching the Flip-it! to the flash

Installing the Flip-it! to the flash.With your left hand, center the reflector panel on the side (short dimension) of your flash for use without a bracket or on the back (long dimension), for use with a camera bracket. Grasp the front of the loop and slip it onto the front of the flash. To remove it, simply slip the front up.

Mounting the Flip-it! on either side of the flashMounting the Flip-it! on Either Side of Your Flash:

The Flip-it! and Diffuser may be mounted on either the long side or short side of your flash.


Changing the angle of the reflector panelChanging the Angle of the Reflector Panel:

When changing the angle, put your thumb on the mounting plate rather than the reflector panel.


Folding the reflector back for direct flash or ceiling bounceDirect flash or ceiling bounce:

The reflector flips back for direct flash or ceiling bounce.




Flip-it! folds flat for storageStorage

Folds flat for storage

 


Understanding How the Reflector Panel Works:

Showing the reflector panel at different angles: back, upright and forwardThe lighting from the rear panel changes as you use different angles. Slightly back of vertical gives the softest light and least shadows. 45° forward gives maximum bounce power when you need it. In-between positions let you fine tune the light as you need.

General Procedure Suggestion

In all photography situations, both indoors and outside, start with the least powerful setting (reflector all the way back). Add power with the reflector only as needed.

Top of page