Demb Flash Bracket Instructions
Demb Flash Bracket Instructions in pdf format
Installation: It is important that your camera be secure on a flat surface while attaching the bracket.
<--
Place the camera on a flat surface on its base and attach both
ends of your TTL cord to the camera hot shoe and the flash base
plate of the bracket. (Left)
-->
Place the camera on its left side so it is stable on the flat
surface. Hold the bracket in your left hand and the camera attachment
screw in your right hand and screw the bracket into the bottom
of the camera. Tightening
the camera screw: Do
not over-tighten.

<-- When not in use, the camera and bracket may be placed on a flat surface as illustrated.

----> Warning: Correct hand position for changing angles
The TTL cord is vulnerable to breakage if the flash is pushed or slapped when changing angles. Canon TTL cords are especially vulnerable to excessive torque. For safety, grasp the cord when changing angles.
Adjusting the hinge tension: The hinge has been designed with a stabilizer bar to keep the tension constant and to prevent "flopping". The tension may be adjusted periodically to your taste with any wrench. Look at the wrench as you tighten or loosen the nut, and adjust only a tiny bit at a time to your taste.